Omron K6CM User Manual page 166

7 Motor Monitoring and Operation with the K6CM Devices and the Motor condition monitoring Tool
2
When the trigger mode is "Always (while power is ON)", measuring and monitoring will be
started.
Measured value is displayed on the numeric display LCD on the front of the device. At the same
time, "MON" of the state display on the front of the device gets lit.
• When the trigger mode is "external trigger", operate the external input.
• When the trigger mode is "internal trigger", wait until the state of the measured value
becomes the start condition of measuring and monitoring.
3
When the trigger mode is "external trigger" or "internal trigger", when measuring and monitoring
is started, the numeric display LCD on the front of the device switches from "- - - -" to the mea-
surement value display. At the same time, "MON" of the state display on the front of the device
gets lit.
Numeric LCD display
Changes from "- - - -" to the
measurement value display.
Status display
"MON": Measurement and
monitoring in progress
*1. As long as "display value selection" is not set to "minimum value" or "maximum value" by the Motor condition
monitoring Tool or EtherNet/IP, the "current value / minimum value / maximum value type of measurement
value" on the front of the device "PV" lights up, and the numerical display shows "current value".
7 - 4
*1
Unit of measurement value
(monitoring category)
Types of measurement such as
current value, minimum value,
and maximum value.
K6CM Motor Condition Monitoring Device User's Manual (N219)
*1