Removing Wires From The Push-In Plus Terminal Block; Recommended Ferrules And Crimp Tools - Omron K6CM User Manual

4-3-4

Removing Wires from the Push-In Plus Terminal Block

Use the following procedure to remove wires from the terminal block.
The same method is used to remove stranded wires, solid wires, and ferrules.
1
Hold a flat-blade screwdriver at an angle and insert it into the release hole.
2
With the flat-blade screwdriver still inserted into the release hole, remove the wire from the ter-
minal insertion hole.
3
Remove the flat-blade screwdriver from the release hole.
4-3-5

Recommended Ferrules and Crimp Tools

Recommended ferrules
Applicable wire
2
AWG
(mm )
0.25 24
0.34 22
0.5 20
0.75 18
1/1.25 18/17
1.25/1.5 17/16
Recommended crimp tool
K6CM Motor Condition Monitoring Device User's Manual (N219)
<Upper side>
(2)
Wire
(3)
(1)
Flat-blade screwdriver
10 to 15°
Flat-blade
screwdriver
Stripping
Ferrule Conduc-
length (mm)
tor length (mm)
(Ferrules used)
8 10
10 12
8 10
10 12
8 10
10 12
8 10
10 12
8 10
10 12
8 10
10 12
4 Installation and Wiring
<Lower side>
Flat-blade
screwdriver
(3)
(1)
Wire
(2)
Flat-blade
screwdriver
10 to 15°
Recommended ferrules
Manufactured Manufactured
by Phoenix Contact by Weidmuller
AI 0,25-8 H0.25/12
AI 0,25-10
AI 0,34-8 H0.34/12
AI 0,34-10
AI 0,5-8 H0.5/14
AI 0,5-10 H0.5/16
AI 0,75-8 H0.75/14
AI 0,75-10 H0.75/16
AI 1-8 H1.0/14
AI 1-10 H1.0/16
AI 1,5-8 H1.5/14
AI 1,5-10 H1.5/16
CRIMPFOX6 PZ6 roto
CRIMPFOX6T-F
CRIMPFOX10S
Manufactured
by Wago
FE-0.25-8N-YE
---- ----
FE-0.34-8N-TQ
---- ----
FE-0.5-8N-WH
FE-0.5-10N-WH
FE-0.75-8N-GY
FE-0.75-10N-GY
FE-1.0-8N-RD
FE-1.0-10N-RD
FE-1.5-8N-BK
FE-1.5-10N-BK
Variocrimp4
4 - 17
4