Changing The Monitoring Category, And Checking The Measured Values; Measuring And Monitoring Completed - Omron K6CM User Manual

7 Motor Monitoring and Operation with the K6CM Devices and the Motor condition monitoring Tool
7-2-2 Changing the Monitoring Category, and Checking the Measured
Values
1
If necessary, switch the monitoring category by pressing the [DISP] key on the front of the
device.
Each time you press the [DISP] key, the measurement unit (monitoring category) changes.
Monitor Type
Vibration & temperature
type
Insulation resistance type
Comprehensive current
diagnosis type
7-2-3

Measuring and Monitoring Completed

1
When the trigger mode is "external trigger" or "internal trigger", when measuring and monitoring
is completed, the measured value of the numerical display LCD on the front of the K6CM is
retained. Also, the status at the end of measuring and monitoring is retained for the alarm bar
and transistor outputs 1 and 2.
At this time, "MON" in the status display on the front of the K6CM goes out.
K6CM Motor Condition Monitoring Device User's Manual (N219)
LCD indicating the unit (Monitoring
category) of the measurement value
Numeric LCD display:
The numerical value in the above
measurement unit is displayed.
Switching the monitoring category:
Press the [DISP] key.
LCD indicating the unit of
measurement value
"G"
↓
"mm/s"
↓
"T"
↓
"ΔT"
"MΩ"
↓
"mA"
"Cim"
↓
"A"
Monitoring category
Acceleration
Velocity
Motor temperature
Temperature Gap (i.e., the difference from the room
temperature of the motor temperature)
Insulation resistance
Leakage current
Degradation level
Current
7
7 - 5