Procedure - Omron K6CM User Manual

1 Overview
1-5

Procedure

The K6CMs can be used in the following procedure.
Step
1. Initial setting
on desk
2. Installation
and Wiring
3. Setting with
actual sys-
tem configu-
ration (via
hub)
1 - 18
Procedures
Prepare a PC with Windows 7 or higher and Ethernet
cables.
Install the Motor condition monitoring Tool.
Start the Motor condition monitoring Tool.
Connect the Motor condition monitoring
Tool directly to the K6CM device via
Ethernet cable.
Turn ON the power to the K6CM device
Select [Create Project],
• Set the IP address of each K6CM device
• Set parameters (when necessary)
• Download IP address and (when necessary) parameters
to K6CM device.
• (When necessary) Set the motor name (K6CM group
name) of each K6CM.
Install.
Wire.
Connect the Motor condition monitoring Tool to the K6CM
device (s) via hub.
(When necessary) Change the parameters and download to
each K6CM device.
Turn ON the power of the K6CM again and activate the
parameters.
↓
↓
Either order is
acceptable
↓
▼
↓
▼
↓
↓
▼
K6CM Motor Condition Monitoring Device User's Manual (N219)
Reference
Section 5 Setting with
the Motor condition
monitoring Tool
Section 2 Nomencla-
ture and Functions
Section 4 Installation
and Wiring
Section 5 Setting with
the Motor condition
monitoring Tool