Omron K6CM User Manual page 72

3 Mechanism of Measuring and Monitoring of the K6CM Devices
Depending on the trigger mode and status, the following operations are performed.
Trigger mode and status
Always While the power is
ON
External trigger Measuring and moni-
input toring Not yet
During measuring
Or
and monitoring
Internal trigger
After measuring and
monitoring
 Example of Operation When the Trigger Mode Is "Always"
Measured value
Present value
Maximum value
Minimum value
3 - 20
Maximum and minimum measure-
Update the maximum and minimum val-
ues of each measurement value after
power-on.
Measuring and monitoring is stopped ("- - - -" is displayed)
Update the maximum and minimum val-
ues of each measurement value from
the measuring and monitoring start.
Maximum and minimum values are
retained.
A
B
Power ON
(*1)
Measuring
and monitoring
During measuring and
monitoring
Updated
Updated
*1.In the above figure, the power-ON state and the unmeasured state (i.e., the state until
the measured value is calculated) that exist immediately after turning ON the power
as shown on page 3-5 are omitted.
ment values
The current value at that time is updated
and then will be updated.
The current value at that time is updated
and then will be updated.
Reset to 0.
Power ON the next time
Updated
A
B
K6CM Motor Condition Monitoring Device User's Manual (N219)
When resetting the maximum and min-
imum value with the Motor condition
monitoring Tool or the EtherNet/IP
Maximum value
Minimum value
Time
Measuring
and monitoring
During
measuring and
monitoring
Updated
Updated
Updated