Omron K6CM User Manual page 83

Precautions for Correct Use
The sensor head and the pre-amplifier are calibrated and inspected as a set at the factory ship-
ment. Be sure to use them with the combination shipped. The sensor head cannot be replaced.
To verify the combination, check the serial numbers on the label of the sensor head and the
label of the pre-amplifier. The same serial number means the correct combination.
If you change the combination of factory shipping conditions and then use them, the value of
acceleration and the value of velocity will be inconsistent, so measurement cannot be correctly
monitored.
Mounting Vibration Sensor Head Easily
For the K6CM-VBS1 (M6 × 8 mm), a magnet for easy-mounting of the sensor is included.
The easy-mounting magnet is used for positioning of measuring place. Note that measurement accu-
racy is not guaranteed in the case of magnet mounting.
The connection between the pre-amplifier and the sensor head is a connector connection.
K6CM Motor Condition Monitoring Device User's Manual (N219)
(01)04549734178730
(21)1342177281
MES:Ver.1.0
The number following (21) in the second line
is the serial number.
Make sure that this number on the sensor
head's label matches the number on the
pre-amplifier's label.
Sensor Easy mounting magnet
23-mm dia.
4 Installation and Wiring
(01)04549734178730
(21)1342177281
MES:Ver.1.0
OMRON Corporation
MADE IN JAPAN
4
4 - 9