Installation And Uninstallation, Starting Up; Installing .Net Framework 3.5 Sp1 - Omron K6CM User Manual

5 Setting with the Motor condition monitoring Tool
5-2 Installation and Uninstallation, Start-
ing up
This section describes how to install and uninstall the Motor condition monitoring Tool and how to start
it.
5-2-1

Installing .NET Framework 3.5 SP1

The Motor condition monitoring Tool requires Microsoft .NET Framework 3.5 SP1 to run the program.
If .NET Framework 3.5 SP1 is not installed on your computer, install it manually.
It is installed as a standard on Windows 7 computer. Follow steps 2 to 4 below.
It is not installed as a standard on Windows 8.1 and Windows 10 computer.
When using on a computer with Windows 8.1 or Windows 10, perform the steps 2 to 4 after installing
the .NET Framework 3.5 SP1 shown in the following step 1.
1
Install .NET Framework 3.5 SP1.
 Installing by connecting the computer to the network
4-1) Install by "dotnetfx35.exe" in the Framework folder on the CD.
4-2) If you use Japanese 32bitOS, install language pack by "dotnetfx35langpack _ x64ja.exe" in
Framework folder on CD.
If you use Japanese 64bit OS, install language pack by "dotnetfx35langpack _ x86ja.exe" in Frame-
work folder on CD.
 Installing without connecting the computer to the network
This procedure shows how to install the Motor condition monitoring Tool (and attached software) on
PCs (Windows 8.1 or Windows 10 OS) that cannot connect to the network.
What are required to prepare:
• Network connected computer
• Empty recording medium (USB memory of 8GB or more, HDD or DVD)
This procedure also details the resolution technique published on the following Microsoft official
website.
Microsoft official website URL:https://msdn.microsoft.com/en-US/library/windows/hard-
ware/dn898529(v=vs.85).aspx#nointerent
Note In Windows version 8.1 or later OS version, the "Microsoft .NET Framework 3.5" required for installing
the above mentioned attached software is not installed in advance. Therefore, if you are using a com-
puter with the above OS version and cannot connect to the network, you cannot acquire the above.
NET and you cannot install the software included with the Motor condition monitoring Tool.
5 - 6
K6CM Motor Condition Monitoring Device User's Manual (N219)