4-2-3
Installation of Pre-amplifier
The pre-amplifier used for Vibration & temperature type (K6CM-VBM) can be mounted on a DIN rail or
mounted on a wall with an M3 screw.
The mounting method is the same as K6CM device.
Vibration & temperature pre-amplifier
K6CM-VBS1
4-2-4
Installation of Vibration Sensor Head
The vibration sensor head for Vibration & temperature type (K6CM-VBM) should be mounted to the
motor to be monitored.
When vibration sensor head is fixed
Turn the screw vertically to the upper side of the shaft side exterior of the induction motor, and attach
the sensor head.
Mount the vibration sensor head vertically to the upper shaft side of the motor
K6CM Motor Condition Monitoring Device User's Manual (N219)
Mounting with M3 screw
or
DIN Track mounting
Three-phase induction motor
4 Installation and Wiring
4
4 - 7