8 Monitoring and Setting with the EtherNet/IP
8-1
Overview
This section describes how to monitor the K6CM devices using the EtherNet/IP.
8-1-1
What is Monitoring Using EtherNet/IP?
The K6CM devices can be monitored from commercially available PC software and PLC or Controller
via EtherNet/IP.
The following two communications methods can be used.
Communications
method
Tag data link
CIP message communi-
cations
Note that EtherNet/IP enables simultaneous execution of these two types of communication methods.
PLC (supporting EtherNet/IP)
Tag data link: monitoring
CIP message communications:
monitoring and setting
8 - 2
Outline
This is a method of exchanging data in preset areas
cyclically (at regular intervals).
Communication instructions are not used.
This is a method of accessing specified data when nec-
essary.
Use the communications instructions.
Industrial switching hub
EtherNet/IP
K6CM Motor Condition Monitoring Device User's Manual (N219)
Monitoring
Supported
Supported
PC (supporting EtherNet/IP)
CIP message communications:
monitoring and setting
K6CM
EtherNet/IP port
For the K6CM devices
Settings
Not sup-
ported
Supported