Omron K6CM User Manual page 175

Tag Data Link
The current values of K6CM are sent cyclically to the specified area of the PLC.
• The PLC assigns I/O memory address or variables to the input tag set. The size must be the same as
the internal data size of the K6CM.
• The K6CM assigns an identification number (instance ID) of a predetermined tag data link internal
data to the output tag set. The data size is fixed to 44 bytes (common to models).
 Configuration tool
When configuring with OMRON controllers, the following setting tools for the tag data link should be
used.
When tag data link is made between CS/CJ-series
PLCs or other company PLCs and and the K6CM
devices
When tag data link is made between NJ/NX-series
Controller and the K6CM devices
 Connection to be created
• Using the Network Configurator
1
Install and start
(1) Install Network Configurator.
(2) Start Network Configurator.
(3) Download the K6CM EDS file from our I-Web and install it on the Network Configurator.
2
Configuration
(1) Register PLC and K6CM devices in the network configuration and set the IP address.
(2) Configure settings to add a connection between devices (i.e., "make a connection").
Note Things to check beforehand:
K6CM Motor Condition Monitoring Device User's Manual (N219)
Configurations
• Which memory area (I/O memory or variables) in the PLC should be used for the
tag data link.
• The size of the internal data (parameter) of the K6CM is 44 bytes for all models.
2)-1 Drag a K6CM to the PLC and register it.
2)-2 Click the [Edit Tag Sets] Button to create input tags with the above sizes.
2)-3 Register the input tag as it is as input tag set.
2)-4 Select the input tag set created in 2) -3 above from the pull-down list.
2)-5 Register the connection.
8 Monitoring and Setting with the EtherNet/IP
Tag data link setting tool (configuration tool) to
Network Configurator
Network Configurator or Sysmac Studio
be used
8 - 3
8