Omron K6CM User Manual page 67

Always (while power is ON)
Trigger is not used. Measuring and monitoring is performed at all times after turning ON the power of
the K6CM device.
The period from power-ON until the next power-on again is the measuring and monitoring period (the
period of maximum value and minimum value calculation).
External trigger (excluding K6CM-ISM)
Measurement and monitoring can be performed at any required timing by inputting a trigger from the
outside according to the operation state of the motor.
Measuring and monitoring is started according to the state of the external input.
Specify "Trigger type" for either execution of measuring and monitoring at the rising or falling edge of
the external input and execution for each specified time or execution while the external input is ON.
The period from the start to the end of the measuring and monitoring is the measuring and monitoring
period (also, the period of maximum and minimum calculation).
K6CM Motor Condition Monitoring Device User's Manual (N219)
3 Mechanism of Measuring and Monitoring of the K6CM Devices
Power ON
Measuring
Measured
Sensor
value
External input (*1)
For Trigger type, select one of the following.
• Rising edge:
Start when external input
changes from OFF to ON, End
after specified time
• Falling edge:
Start when external input
changes from ON to OFF, End
after specified time
• Level:
While the external input is in
the ON state
Measuring
*1. External input can be either a no-voltage reed or an open collector.
Monitoring
Critical
Warning
The specified time
ON
Measuring and
monitoring
OFF
The specified time
ON
Measuring and
OFF
monitoring
ON
Measuring and
OFF
monitoring
Monitoring
3
3 - 15