4 Installation and Wiring
1
Turn the screw vertically to the upper side of the shaft side exterior of the induction motor, and
mount the sensor head.
The position above the bearing is recommended for the position to cut the tap.
Bearing
Axis
2
Screw the screw thread at the tip of the vibration sensor head into the screw hole and install.
(Recommended tightening torque is 4.4 to 5.4 N•m or less)
4 - 8
Tap the top of the bearing
Mounting vertically
M6 thread (coarse)
Bearing
Three-phase induction motor
Screw
K6CM Motor Condition Monitoring Device User's Manual (N219)