Omron K6CM User Manual page 48

2 Nomenclature and Functions
 Transition of Numeric LCD Display
The numerical LCD display will transition as follows after turning ON the power supply or after soft-
*1
ware reset
When the power
supply is turned ON
or the software reset
Power OFF
is done.
No lit.
*1. It depends on the Software reset button operation from the Motor condition monitoring Tool or software reset
command from EtherNet/IP.
 Push-In Plus Terminals Layout
Power supply to the device
External trigger
input (+)
External trigger
input (-)
Not used.
Not used.
2 - 6
.
*1
All lit
10 seconds or less
Transistor Output 1 (+)
Transistor Output 1 (-)
Transistor Output 2 (+)
Transistor Output 2 (-)
Transistor Output 3 (+)
Transistor Output 3 (-)
When measurement and
monitoring condition is met
"MON" goes on
Measured value displayed
Measurement and monitoring conditions were met.
Measurement and monitoring is not started yet
"MON" goes off
"- - - -" displayed "ERR" goes on when the sensor
is not connected.
Input range over occurs.
"MON" goes on
7 segment blinking
VBS 0:
Sensor input (+)
VBS 2:
Supply to
sensor 10 V (+)
IRT0:
Sensor input (+)
IRT2:
Supply to
sensor 10 V (+)
CTK
K6CM Motor Condition Monitoring Device User's Manual (N219)
After measuring and monitoring
(only when using the trigger)
"MON" goes off
Measurement and monitoring is
not done (only when using the
trigger function)
K6CM-VB
Vibration & temperature type
VBS 1:
Sensor input (-)
VBS 3:
Supply to
sensor 10 V (-)
K6CM-IS
Insulation resistance type
IRT1:
Sensor input (-)
IRT3:
Supply to
sensor 10 V (-)
K6CM-CI
Vibration & temperature type
CTL