Motor Monitoring And Operation Procedure - Omron K6CM User Manual

7 Motor Monitoring and Operation with the K6CM Devices and the Motor condition monitoring Tool
7-1 Motor Monitoring and Operation Pro-
cedure
This section describes the monitoring and operating the motor using the K6CM.
It is generally difficult to set the alarm setting (threshold) of the K6CM at the time of start of use.
Therefore, the actual motor monitoring and operation method depends on the following procedure.
1
Start measuring with the K6CM devices.
STEP
↓
Record measurement values from the host system (i.e., the Motor condition monitoring Tool, PC,
or PLC) to estimate an alarm set value to be used as the monitoring standard.
2
• With the Motor condition monitoring Tool, set the "Monitoring cycle" by pressing the [Option] But-
STEP
ton, before monitor via EtherNet/IP and log the measurement values.
• With PC or PLC, Monitor via EtherNet/IP and log the measurement values.
↓
Estimate an alarm set values to be used as monitoring standard, considering the relationship
3
STEP
between the change in each measurement value and the fatal state of the motor.
↓
Determine the alarm set values as the monitoring standard based on the monitoring and operation
4
STEP
results.
↓
5
Change the setting of the alarm set values and make main monitoring and operation.
STEP
7 - 2
K6CM Motor Condition Monitoring Device User's Manual (N219)