Omron K6CM User Manual page 133

• [Device setting] Button
The following [K6CM configuration setting] Dialog Box is displayed.
(1) Change the IP address of the device.
IP address, subnet mask, default gateway.
• [Monitoring setting] Button
The following [K6CM monitoring setting K6CM Monitoring cycle] Dialog Box is displayed.
(1) Change the monitoring cycle.
It can be set in the range of 1 to 99999 seconds (the initial value is 10 minutes of 600 sec-
onds).
The monitoring cycle is the cycle at which the Motor condition monitoring Tool collects mea-
sured values from the K6CM devices.
The measured values are collected by the Motor condition monitoring Tool at that cycle,
regardless of the K6CM device state such as the use of trigger or the determination of mea-
sured value.
Precautions for Correct Use
If the monitoring cycle is too short, depending on the performance of your PC, the operation of
the Motor condition monitoring Tool may be delayed and may not operate at the set monitoring
cycle.
Set the monitoring cycle according to the performance of your PC. Also, if the size of the log file
increases, depending on the performance of your computer, the operation of the Motor condi-
tion monitoring Tool may be delayed. In that case, periodically save the log files and move them
to another llocations.
K6CM Motor Condition Monitoring Device User's Manual (N219)
5 Setting with the Motor condition monitoring Tool
5
5 - 33