Using The Ethernet/Ip - Omron K6CM User Manual

9 Trouble shooting
9-3

Using the EtherNet/IP

This section shows troubleshooting when using the EtherNet/IP.
EtherNet/IP communica-
tions can not be executed
when using BOOTP mode
9 - 4
Problems
NS LED blinking red IP address has not been
Cause Possible correction
Check the connection
acquired from the between BOOTP server and
BOOTP server the K6CM devices.
If you do not have a BOOTP
server, press the [ALM RST]
key and the [DISP] key at the
same time for five seconds
or more to initialize all set-
tings of the K6CM device.
K6CM Motor Condition Monitoring Device User's Manual (N219)
Reference
----