Set Parameters - Omron K6CM User Manual

5 Setting with the Motor condition monitoring Tool
5-4-4

Set Parameters

Parameter settings can be set in either of the following two ways:
• How to set in the start navigation of project creation
• How to set on the device setting screen after project creation
The following shows the setting method on the device setting screen. For details on how to set it in the
project creation procedure, refer to 5-4-3 Procedure for Setting IP Address (when necessary, further
parameters) on page 5-37.
If parameter setting in project creation is not completed, set the parameters of each K6CM device
according to the actual system configuration via the hub if necessary.
Because each K6CM device already has an IP address, you can access multiple forms K6CM via the
hub from the Motor condition monitoring tool.
It depends on the following procedure.
1
Connect the Motor condition monitoring Tool to the K6CM via the hub.
2
Click the
The following device setting screen is displayed.
3
Select the K6CM.
4
Set the parameters of each K6CM device. (For details, refer to 6-2 Settings on page 6-3.)
5
Click the
6
Turn the K6CM power supply ON again. Or click the
right of the parameter list on the device setting screen.
5 - 46
[Device setting] Button.
[Downloading (PC→device)] Button to download the parameters.
[Software reset] Button on the upper
K6CM Motor Condition Monitoring Device User's Manual (N219)