Add A Device To An Existing Project - Omron K6CM User Manual

Precautions for Correct Use
After downloading the parameters to the device, turn the power of the K6CM ON again, or click
the
screen in order to validate the parameter setting. With downloading, the parameter setting will
not be effective.
5-4-5

Add a Device to an Existing Project

If you want to add a device on the project, perform the following operations.
After adding the device, connect with the factory default IP address and change its IP address.
1
Click the
The following [K6CM Configuration setting] Dialog Box is displayed.
2
In the [Motor name], select the motor name to which the device belongs.
Precautions for Correct Use
• It is not possible to register the same type of device in the same motor (device group) name.
• Up to 3 devices can be registered in the same motor (device group) name.
3
Select the device type in the [Device type].
4
Enter the factory default IP address "192.168.250.10" in the [IP Address].
5
Click the [Add] Button.
6
Click the [End] Button.
7
Select the added device, click the
The following [K6CM configuration setting] Dialog Box is displayed.
K6CM Motor Condition Monitoring Device User's Manual (N219)
5 Setting with the Motor condition monitoring Tool
[Software reset] Button at the upper right of the parameter list on the device setting
[Add device] Button on the setting screen tool button.
[Device setting] Button on the setting screen tool button.
5
5 - 47