Setting To Output System Information To A Monitor Terminal - 3Com 4200G 12-Port Configuration Manual

Follow these steps to enable the system information display on the console:
To do...
Enable the debugging/log/trap
information terminal display
function
Enable debugging information
terminal display function
Enable log information terminal
display function
Enable trap information
terminal display function
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.

Setting to Output System Information to a Monitor Terminal

System information can also be output to a monitor terminal, which is a user terminal that has login
connections through the AUX, VTY, or TTY user interface.
Setting to output system information to a monitor terminal
Follow these steps to set to output system information to a monitor terminal
To do...
Enter system view
Enable the information center
Enable system information
output to Telnet terminal or
dumb terminal
Configure the output rules of
system information
Use the command...
terminal monitor
terminal debugging
terminal logging
terminal trapping
Use the command...
system-view
info-center enable
info-center monitor channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
1-10
Remarks
Optional
Enabled by default.
Optional
Disabled by default.
Optional
Enabled by default.
Optional
Enabled by default.
Remarks
—
Optional
Enabled by default.
Optional
By default, a switch outputs
log/debugging/trap information
to a user terminal through
information channel 1.
Optional
Refer to Table 1-4 for the
default output rules of system
information.