Dhcp Parameters - AudioCodes Mediant 500L User Manual

Parameter
[SRV2IP]

69.2.7 DHCP Parameters

The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Parameter
Enable DHCP
[DHCPEnable]
[DhcpOption160Support]
[DHCP120OptionMode]
[DHCPSpeedFactor]
User's Manual
The format of the ini file table parameter is:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
For more information, see ''Configuring the Internal SRV Table'' on page
167.
Table 69-15: DHCP Parameters
Enables DHCP client functionality.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

For a detailed description of DHCP, see ''DHCP-based Provisioning''
on page 829.

The parameter is a "hidden" parameter. Once defined and saved to
flash memory, its value doesn't revert to default even if the parameter
doesn't appear in the ini file.
Enables the use of DHCP Option 160.

[0] = (Default) Disable

[1] = Enable
For more information, see "Provisioning the Device using DHCP Option
160" on page 832.
Note: For the parameter to take effect, a device reset is required.
Enables the acceptance of DHCP Option 120 in DHCP responses sent
by a DHCP server.

[0] = DHCP Option 120 is not supported and ignored if received in the
DHCP response.

[1] = (Default) DHCP Option 120 is supported and if received, the
device adds the SIP server information to the Proxy Set.
Defines the device's DHCP renewal speed for a leased IP address from
a DHCP server.

[0] = Disable

[1] = (Default) Normal

[2] to [10] = Fast
1026
Mediant 500L Gateway & E-SBC
Description
Description
Document #: LTRT-10532