Dhcp Parameters - AudioCodes Mediant 3000 User Manual

User's Manual
Parameter

53.1.8 DHCP Parameters

The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Parameter
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
EMS: DHCP Speed
Factor
[DHCPSpeedFactor]
Version 6.6
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
Note: For a detailed description of this table parameter, see
'Configuring the Internal SRV Table' on page 134.
DHCP Parameters
Enables Dynamic Host Control Protocol (DHCP) functionality.

[0] Disable (default)

[1] Enable
After the device powers up, it attempts to communicate with a BootP
server. If a BootP server does not respond and DHCP is enabled, then
the device attempts to obtain its IP address and other networking
parameters from the DHCP server.
Notes:

For this parameter to take effect, a device reset is required.

After you enable the DHCP server, do the following:
a. Enable DHCP and save the configuration.
b. Perform a cold reset using the device's hardware reset button
(soft reset using the Web interface doesn't trigger the
BootP/DHCP procedure and this parameter reverts to 'Disable').

Throughout the DHCP procedure, the BootP/TFTP application must
be deactivated; otherwise the device receives a response from the
BootP server instead of from the DHCP server.

This parameter is a special 'Hidden' parameter. Once defined and
saved in flash memory, its assigned value doesn't revert to its default
even if the parameter doesn't appear in the ini file.
Defines the DHCP renewal speed.

[0] = Disable

[1] = (Default) Normal

[2] to [10] = Fast
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
Note: For this parameter to take effect, a device reset is required.
651
53. Configuration Parameters Reference
Description
Description
Mediant 3000