Brake Fluid - Can-Am MAX 400 EFI Operator's Manual

NOTE: When checking level at tem-
perature lower than 20°C (68°F), it
may be slightly lower than MIN. mark.
vmo2008-019-013_a
UNDERNEATH LH FRONT FENDER
1. Reservoir
2. MAX. level mark
3. MIN. level mark
Add coolant up to MAX. mark if re-
quired. Use a funnel to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap.
If the coolant is added in the coolant
reservoir, check the level in the radia-
tor too. Add coolant if necessary.
WARNING
In order to avoid potential burning,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Can-Am dealer.
Reinstall service compartment panel.

Brake Fluid

Recommended Fluid
Always use brake fluid meeting the
specification DOT 4 only.
______________________
92
CAUTION: To avoid serious dam-
age to the braking system, do not
use fluids other than the recom-
mended one, nor mix different
fluids for topping up.
Fluid Level
With vehicle on a level surface, check
brake fluid in reservoirs for proper lev-
el. They should be above MIN. mark.
Add fluid as required. Do not overfill.
Clean filler cap before removing.
CAUTION: Use only DOT 4 brake
fluid from a sealed container. Do
not use brake fluid taken from old
or already opened containers.
NOTE: A low level may indicate leaks
or worn brake pads. See an autho-
rized Can-Am dealer.
Brake Lever Fluid Reservoir
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
vmo2006-016-004_a
TYPICAL — ON HANDLEBAR