Rotor - Can-Am DS 450 2008 Shop Manual

Section 03 ENGINE
Subsection 06 (MAGNETO/STARTER)
vmr2008-014-005_b
1. CPS screws
2. Stator wiring harness
Apply Loctite 5910 (P/N 293 800 081) between
CPS and magneto cover as shown.
vmr2008-014-007
Use a new gasket and install magneto cover.

ROTOR

Rotor Removal
Remove magneto cover. Refer to
COVER
above.
Lock crankshaft with crankshaft locking tool
(P/N 529 036 107) at TDC. Refer to
END
.
vmr2008-014-008
Remove rotor retaining screw.
76
vmr2008-014-009_a
1. Screw M8
2. Washer
3. Rotor
Use the screw from the magneto puller (P/N 529
035 748).
vmr2006-041-008
Install the puller screw in rotor.
NOTE: Apply grease on screw threads and screw
tip to prevent damage to the threads during re-
moval.
Tighten puller screw to remove rotor.
The rotor is mounted with Loctite 648 and will be
stuck on the crankshaft. Proceed as follows to
release rotor.
– Use a heat gun and heat rotor.
– Tighten puller screw. Do not overtighten to
avoid damaging threads.
MAGNETO
– Tap the head of puller screw with a hammer.
Rotor should pop out.
– Continue tightening puller screw to remove ro-
BOTTOM
tor.
vmr2008-015