Snmp-Server Enable Traps - Cisco ME 3800X Command Reference Manual

snmp-server enable traps

snmp-server enable traps
To enable the switch to send Simple Network Management Protocol (SNMP) notifications for various
traps or inform requests to the network management system (NMS), use the snmp-server enable traps
command in global configuration mode. To return to the default setting, use the no form of this
command.
Syntax Description alarms severity
auth-framework
bgp
bridge [newroot]
[topologychange]
Cisco ME 3800X and ME 3600X Switch Command Reference
-4
snmp-server enable traps [alarms [severity] | auth-framework | bgp | bridge [newroot]
[topologychange] | cef | config | copy-config | cpu threshold | entity | envmon [fan | shutdown
| status | supply | temperature] | ethernet | ether oam | flash | hsrp | ipmulticast |
mac-notification [change] [move] [threshold] | mpls | msdp | ospf [cisco-specific | errors |
lsa | rate-limit | retransmit | state-change] | pim [invalid-pim-message | neighbor-change |
rp-mapping-change] | rtr | snmp [authentication | coldstart | linkdown | linkup | warmstart]
| storm-control trap-rate value | stpx [inconsistency] [root-inconsistency]
[loop-inconsistency] | syslog | transceiver all | tty | vlan-membership | vlancreate |
vlandelete]
no snmp-server enable traps [alarms [severity] | auth-framework | bgp | bridge [newroot]
[topologychange] | cef | config | copy-config | cpu threshold | entity | envmon [fan | shutdown
| status | supply | temperature] | ethernet | ether oam | flash | hsrp | ipmulticast |
mac-notification [change] [move] [threshold] | mpls | msdp | ospf [cisco-specific | errors |
lsa | rate-limit | retransmit | state-change] | pim [invalid-pim-message | neighbor-change |
rp-mapping-change] | port-security [trap-rate value] | rtr | snmp [authentication | coldstart
| linkdown | linkup | warmstart] | storm-control trap-rate value | stpx [inconsistency]
[root-inconsistency] [loop-inconsistency] | syslog | transceiver all | tty | vlan-membership |
vlancreate | vlandelete]
(Optional) Enables SNMP alarms traps. For severity, enter number 1 to 4 or
enter one of these keywords:
•
•
•
•
Enables SNMP CISCO-AUTH-FRAMEWORK-MIB traps
(Optional) Enables Border Gateway Protocol (BGP) state-change traps.
Note
(Optional) Generates Spanning Tree Protocol (STP) bridge MIB traps. The
keywords have these meanings:
•
•
critical—Service-affecting condition, severity 1.
major—Immediate action needed, severity 2.
minor—Minor warning conditions, severity 3.
informational—Informational notifications, severity 4.
This keyword is supported only when the metro IP access image is
running on the switch.
newroot—(Optional) Enables SNMP STP bridge MIB new root traps.
topologychange—(Optional) Enables SNMP STP bridge MIB topology
change traps.
Chapter
OL-28238-01