Snmp-Server Enable Traps - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

snmp-server enable traps

Use the snmp-server enable traps global configuration command to enable the switch to send Simple
Network Management Protocol (SNMP) notifications for various traps or inform requests to the network
management system (NMS). Use the no form of this command to return to the default setting.
Syntax Description
bridge
cluster
config
copy-config
entity
envmon [fan |
shutdown | status |
supply | temperature]
flash
hsrp
ipmulticast
mac-notification
msdp
78-16882-01
snmp-server enable traps [bridge | cluster | config | copy-config | entity | envmon [fan |
shutdown | status | supply | temperature] | flash | hsrp | ipmulticast | mac-notification |
msdp | ospf [cisco-specific | errors | lsa | rate-limit | retransmit | state-change] | pim
[invalid-pim-message | neighbor-change | rp-mapping-change] | port-security [trap-rate
value] | rtr | snmp [authentication | coldstart | linkdown | linkup | warmstart] |
storm-control trap-rate value | stpx | syslog | tty | vlan-membership | vlancreate | vlandelete
| vtp]
no snmp-server enable traps [bridge | cluster | config | copy-config | entity | envmon [fan |
shutdown | status | supply | temperature] | flash | hsrp | ipmulticast | mac-notification |
msdp | ospf [cisco-specific | errors | lsa | rate-limit | retransmit | state-change] | pim
[invalid-pim-message | neighbor-change | rp-mapping-change] | port-security [trap-rate] |
rtr | snmp [authentication | coldstart | linkdown | linkup | warmstart] | storm-control
trap-rate | stpx | syslog | tty | vlan-membership | vlancreate | vlandelete | vtp]
(Optional) Generate STP bridge MIB traps.
(Optional) Enable cluster traps.
(Optional) Enable SNMP configuration traps.
(Optional) Enable SNMP copy-configuration traps.
(Optional) Enable SNMP entity traps.
Optional) Enable SNMP environmental traps. The keywords have these
meanings:
•
•
•
•
•
(Optional) Enable SNMP FLASH notifications.
(Optional) Enable Hot Standby Router Protocol (HSRP) traps.
(Optional) Enable IP multicast routing traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
fan—(Optional) Enable fan traps.
shutdown—(Optional) Enable environmental monitor shutdown traps.
status—(Optional) Enable SNMP environmental status-change traps.
supply—(Optional) Enable environmental monitor power-supply traps.
temperature—(Optional) Enable environmental monitor temperature
traps.
snmp-server enable traps
Catalyst 2960 Switch Command Reference
2-409