2 INSTALLATION AND OPERATION
2.1
INTRODUCTION
This section outlines the methods required to install and operate the OSD2054P successfully. It should
be studied carefully if damage to the equipment or poor results are to be avoided.
This equipment has been fully tested prior to dispatch and is ready for immediate operation. However it
is advisable to check for external transportation damage before operation. If damage is evident, return
the unit with the packaging to your supplier immediately.
2.2
INSTALLATION
2.2.1
WARNING AND PRECAUTIONS
▲
ELECTROMAGNETIC COMPATIBILITY
WARNING: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
▲
OPTICAL OUTPUT OPERATION
WARNING: Laser Safety: Class 1 Laser Product per IEC 60825-1:2014 standard.
PRECAUTIONS
▲
All service personnel should be provided training as to the hazards of direct viewing of laser
radiation and of the precautionary measures during servicing of equipment
Areas where laser products are installed should be restricted in access to trained service
▲
personnel only and appropriate warning signs posted in the work area.
All laser apertures should be covered by protective covers when not connected to optical
▲
fibers. Never leave outputs uncovered.
Laser equipment should be positioned above or below eye level where possible. Apertures
▲
should be positioned away from personnel.
Protective eyewear should be worn in the vicinity of laser equipment.
▲
PAGE 8
OPTICAL SYSTEMS DESIGN
The OSD2054P is a Class 1 laser product.
OSD2054P OPERATOR MANUAL
Class 1
DOC ID: 10116001