Removing The Itb Pressure Release Switch - Canon imageRUNNER C1335 Series Service Manual

4
Disassembly/Assembly > Image Formation System > Removing the ITB Pressure Release Switch > Procedure

Removing the ITB Pressure Release Switch

■ Preparation
1) Remove the Rear Cover 1(Refer to page 4-34).
2) Remove the Fax Unit (to be removed for models equipped with a fax)(Refer to page 4-101).
3) Remove the Main Controller Unit(Refer to page 4-81).
4) Remove the Low-voltage Power Supply PCB Unit(Refer to page 4-93).
5) Remove the DC Controller PCB Unit(Refer to page 4-86).
6) Remove the Main Drive Unit(Refer to page 4-125).
4 Disassembly/Assembly > Image Formation System > Removing the ITB Pressure Release Switch > Procedure
F-4-326
■ Procedure
1) Remove the ITB Pressure Release Switch [1].
• 1 Connector [2]
• Harness Guide [A]
• 1 Claw [3]
• 2 Hooks [4]
NOTE: Actions after assembly
Execute Auto Adjust Gradation and Correct Print Color Mismatch.
Settings/Registration > Adjustment/Maintenance > Adjust Image Quality > Auto Adjust
Gradation > Full Adjust
Settings/Registration > Adjustment/Maintenance > Adjust Image Quality > Correct Print
Color Mismatch
4-130
[2] [4]
1x
1x
[3]
1x
[A]
[4]
[1]
F-4-327
4-130