Canon imageRUNNER C1335 Series Service Manual page 378

Error Detail
Item
code Code
E004 0002 Title Fixing Main Thermistor and Fixing Sub Thermistor (Rear) disconnection
detection error
Description Connection could not be detected within 0.5 sec when power was supplied
to the Fixing Heater.
Remedy [Related parts]
• Fixing Assembly (Unit of replacement: Fixing Assembly)
• Harness between the Fixing Drawer (DR01/J5401) and the DC
Controller PCB (UN04/J134) (Unit of replacement: INTERLOCK
ASSEMBLY)
• DC Controller PCB (UN04) (Unit of replacement: DC CONTROLLER
PCB ASSEMBLY)
[Points to note at work] When checking the harness/cable or connector,
perform the following work.
1. Disconnect and then connect the connector to check that there is no
bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/cable.
[Remedy] Check/replace the related parts.
7
Error•Jam•Alarm > Error Code > Error Code Details
Description
7 Error•Jam•Alarm > Error Code > Error Code Details
Error Detail
Item
code Code
E009 0001 Title Fixing pressure timeout error
Description Signal of the Fixing Pressure Release Sensor could not be detected
at pressure application operation of the Fixing Pressure Release Cam,
and the operation was not completed within 4 sec from the start of
counterclockwise rotation of the Fixing Motor.
Remedy [Related parts]
• Fixing Assembly (Unit of replacement: Fixing Assembly)
• Harness between the Fixing Drawer (DR01/J5401) and the DC
Controller PCB (UN04/J134) (Unit of replacement: INTERLOCK
ASSEMBLY)
• Harness between the DC Controller PCB (UN04/J135) and the Fixing
Motor (M04/J5412) (Unit of replacement: CABLE, FIXING DRIVE)
• Harness between the Fixing Drawer (DR01/J5401) and the Fixing
Pressure Release Sensor (PS13/J5403) (Unit of replacement: CABLE,
FIXING ASSEMBLY)
• Fixing Pressure Release Sensor (PS13) (Unit of replacement: PHOTO
INTERRUPTER)
• Fixing Drive Unit (Unit of replacement: FIXING DRIVE ASSEMBLY)
• DC Controller PCB (UN04) (Unit of replacement: DC CONTROLLER
PCB ASSEMBLY)
• Harness between the Low-voltage Power Supply PCB (UN01/J315
and J322) and the DC Controller PCB (UN04/J20 and J22) (Unit of
replacement: CABLE, POWER SUPPLY)
• Low Voltage Power Supply PCB (UN01) (Unit of replacement: POWER
SUPPLY ASSEMBLY)
[Points to note at work] When checking the harness/cable or connector,
perform the following work.
1. Disconnect and then connect the connector to check that there is no
bent pin and cable disconnection.
2. Visually check that the harness is not caught or open circuit.
3. If there is any error, replace the corresponding harness/cable.
[Remedy] Check/replace the related parts.
7-7
Description
7-7