Lead-Edge Margin Adjustment (1St Side/Normal Paper); Lead-Edge Margin Adjustment (2Nd Side) - Canon imageRUNNER C1335 Series Service Manual

5
Adjustment > Pickup Feed System > Lead-edge Margin Adjustment (2nd side)

Lead-edge Margin Adjustment (1st side/normal paper)

Adjustment 1) Make copies from cassettte 1, and check that the lead-edge margin is L1 = 4.0
procedure +1.5/-1.0 mm. If the lead-edge margin is out of the specification, go through the
following steps to make adjustment.
Feeding direction
of paper
In Case of Nonstandard
2) Select the following in Service Mode: COPIER > ADJUST > FEED-ADJ > REGIST.
3) Change the setting value to make adjustment. (When the setting value is
increased by "1", the leading edge margin is increased by 0.1 mm: Image move to
the trailing edge)
4) Write down the new adjustment value on the service label.
• REGIST
5 Adjustment > Pickup Feed System > Lead-edge Margin Adjustment (2nd side)
image
L1
T-5-56

Lead-edge Margin Adjustment (2nd side)

Adjustment 1) Make copies from cassette 1, and check that the lead-edge margin is L1 = 4.0
procedure +1.5/-1.0 mm. If the lead-edge margin is out of the specification, go through the
following steps to make adjustment.
Feeding direction
of paper
In Case of Nonstandard
2) Select the following in Service Mode: COPIER > ADJUST > FEED-ADJ > REG-
DUP1.
3) Change the setting value to make adjustment. (When the setting value is
increased by "1", the leading edge margin is increased by 0.1 mm: Image move to
the trailing edge)
4) Write down the new adjustment value on the service label.
• REG-DUP1
5-23
image
L1
T-5-57
5-23