Canon imageRUNNER C1335 Series Service Manual page 305

4
Disassembly/Assembly > Pickup/Feed System > Reassembling when the Multi-purpose Tray Separation Roller Shaft is detached > Reassembling when the Multi-purpose Tray Separation Roller Shaft is detache
■ Reassembling when the Multi-purpose Tray Separation Roller
Shaft is detached and dropped inside the host machine
NOTE:
The following describes the state in which the Multi-purpose Tray Separation Roller
Shaft is detached and dropped inside the host machine.
● Preparation
1) Remove the Right Inner Door Unit(Refer to page 4-44).
4 Disassembly/Assembly > Pickup/Feed System > Reassembling when the Multi-purpose Tray Separation Roller Shaft is detached > Reassembling when the Multi-purpose Tray Separation Roller Shaft is detache
● Procedure
1) Remove the Right Cover Stopper Rear Holder [1].
• 1 Screw [2]
2) Lift the Right Cover Stopper Rear [1], and remove the Sensor Harness [2].
• 1 Connector [3]
• Harness Guide [A]
F-4-403
[1]
3) Remove the Multi-purpose Tray Separation Unit [1].
• 3 Screws [2]
• 2 Bosses [3]
1x
[3]
4-155
1x
[1] [2]
F-4-404
1x
[A] [2]
F-4-405
4-155