Removing The Itb Unit - Canon imageRUNNER ADVANCE C3500 III Series Service Manual

CAUTION:
• Remove the Protection Sheet [1] from the replacing Secondary Transfer Outer Roller after installation.
• Pull the tape [2] on the Protection Sheet [1] in the direction of the arrow to remove the sheet.
NOTE:
When the consumable parts have been replaced, be sure to clear the parts counter shown below in service mode.
• COPIER > COUNTER > DRBL-1 > 2TR-ROLL

Removing the ITB Unit

■ Preparation
CAUTION:
If the ITB Unit is replaced in sleep mode or the power is turned OFF in sleep mode, the Primary Transfer Roller is not
disengaged and the ITB Unit can not be pulled out. Set standby mode to replace the ITB Unit.
1. Fully open the Right
[1]
Door."Fully open the Right Door" on page 154
[1]
[2]
209
4. Parts Replacement and Cleaning