Canon imageRUNNER C1335 Series Service Manual page 599

Setting After Installation
1) COPIER > FUNCTION > INSTALL > CARD-NUM, and enter the first number of the card to
be used.
Enter the smallest card number to be used by the user.
• Service Mode > COPIER > FUNCTION > INSTALL > CARD-NUM
2) Sequence numbers beginning with the number specified in COPIER > FUNCTION >
INSTALL > CARD are automatically registered.
From the entered card number, 300 cards can be used.
3) Select ON for the Dept ID control.
• Menu > System Settings > Dept.ID manegement On/Off > ON > OK
4) Turn OFF and then ON the main power switch to enable the setting values.
5) Check that a message [You must insert a control card.] appears.
NOTE:
Perform the following operations to change the number of cards (departments) after it
has been set. In such a case, counter information for each department is reset.
• Select OFF for the Dept ID Management.
• Service mode : COPIER > FUNCTION > CLEAR > CARD
• Clear E719.
Service Mode > COPIER > FUNCTION > CLEAR > E719-CLR
• Turn OFF and then ON the main power switch to enable the setting values.
• After that, perform the setup procedure again from step 1.
9
Installation > Copy Card Reader-F1 > Setting After Installation
9 Installation > Copy Card Reader-F1 > Setting After Installation
9-27
9-27