Canon imageRUNNER C1335 Series Service Manual page 232

4
Disassembly/Assembly > Controller System > Removing the Main Controller Unit > Procedure
3) Remove the Main Controller Cover [1].
• 1 Connector [2]
• 6 Screws [3]
• 2 Hooks [4]
1x
6x
[4]
[3]
[2]
4) If the Fax Unit is installed, remove the Edge Saddle [2] and the 3 connectors [1].
1x
3x
[2]
[1]
4 Disassembly/Assembly > Controller System > Removing the Main Controller Unit > Procedure
5) Remove the harness connected to the Main Controller Unit [1].
• 8 Connectors [2]
• 1 Control Panel Communication Connector [3]
• 3 Flat Cables [4]
• 3 Wire Saddles [5]
• 1 Edge Saddle [6]
[1]
Note: How to remove the Flat Cable
There are 2 types of Flat Cables on the Main Controller PCB.
They can be removed as follows.
[4]
Type 1:
1. Raise the Fixation Member [1].
2. Lift and remove the Flat Cable [2].
F-4-192
Type 2:
1. Pull out the Fixation Member [1].
2. Pull out the Flat Cable [2].
[1]
F-4-193
[1] [2]
F-4-194
[1]
[2]
F-4-195
4-82
4-82