Canon imageRUNNER C1335 Series Service Manual page 596

11) Remove the Lower Cover of the Card Reader Unit, and change the position of the
cable.
• 1 Screw (Removed screw will be used in a later step)
12) Install the Lower Cover of the Card Reader Unit.
• 1 Screw (Use the screw removed in the previous step)
1x
13) Install the Card Reader Unit to the Card Reader Mounting Plate (front) Unit.
• 2 Bosses
• 1 Toothed Washer
• 1 Screw(RS Tightening; M4x10)
• 1 Wire Saddle
1x
Boss
RS tight
M4x10
9
Installation > Copy Card Reader-F1 > Installation Procedure
14)
Reader Unit.
• 1 Connector
• 1 Edge Saddle
CAUTION:
Be sure that the core is inside the Edge Saddle.
1x
F-9-65
15)
Face Seals will not be used.)
1x
F-9-66
9 Installation > Copy Card Reader-F1 > Installation Procedure
Connect the Card Reader External Relay Harness to the connector of the Card
1x
Remove the 2 Face Seals from the right side of the host machine. (The removed
9-24
1x
F-9-67
F-9-68
9-24