Removing The Toner Bottle Mount (Y/M/C/Bk) - Canon imageRUNNER C1335 Series Service Manual

Table of Contents

Advertisement

4
Disassembly/Assembly > Image Formation System > Removing the Toner Bottle Mount (Y/M/C/Bk) > Preparation (for the Toner Bottle Mount (Y/M/C))
NOTE: How to install the Bottle Drive Unit (C Bk)
Be sure to align the hole [A] of the gear with the protrusion [B] of the shaft to install the
unit.
[A]
[B]
4
Disassembly/Assembly > Image Formation System > Removing the Toner Bottle Mount (Y/M/C/Bk) > Preparation (for the Toner Bottle Mount (Y/M/C))

Removing the Toner Bottle Mount (Y/M/C/Bk)

■ Preparation (for the Toner Bottle Mount (Y/M/C))
1) Remove the Rear Cover 1(Refer to page 4-34).
2) Remove the Fax Unit (to be removed for models equipped with a fax)(Refer to page 4-101).
3) Remove the Main Controller Unit(Refer to page 4-81).
4) Remove the Low-voltage Power Supply PCB Unit(Refer to page 4-93).
5) Remove the DC Controller PCB Unit(Refer to page 4-86).
6) Remove the Main Drive Unit(Refer to page 4-125).
7) Remove the Waste Toner Container(Refer to page 4-108).
8) Remove the Toner Container (Y/M/C/Bk) (remove the toner container of the color to be
removed)(Refer to page 4-109).
9) Remove the Drum Unit (Y/M/C/Bk) (remove the drum Unit of the color to be removed)(Refer
to page 4-109).
10) Remove the ITB Unit(Refer to page 4-112).
11) Remove the Left Lower Cover(Refer to page 4-36).
12) Remove the Primary Transfer High-voltage PCB Unit(Refer to page 4-90).
F-4-332
4-132
F-4-333
4-132

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Imagerunner c1325 series

Table of Contents