Canon imageRUNNER C1335 Series Service Manual page 467

COPIER> ADJUST> CCD
MTF2-M4 MTF value 4 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
MTF2-M5 MTF value 5 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
MTF2-M6 MTF value 6 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
8
Service Mode > COPIER > ADJUST > CCD
8 Service Mode > COPIER > ADJUST > CCD
COPIER> ADJUST> CCD
MTF2-M7 MTF value 7 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
MTF2-M8 MTF value 8 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
MTF2-M9 MTF value 9 setting: horz scan [Cpybrd]
Details Setting value for MTF filter coefficient calculation.
Enter the value of service label on the Reader.
Use case • When replacing the Scanner Unit
• When replacing the Main Controller PCB/clearing the Reader-related
RAM data
Adj/set/operate method 1) Enter the setting value and press Start key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service
label.
Display/adj/set range 0 to 100
Unit 1 %
Default value 100
8-28
8-28