Canon imageRUNNER C1335 Series Service Manual page 516

COPIER> FUNCTION> MISC-P
1ATVC-EX Execute of primary transfer ATVC control
Details To execute the primary transfer ATVC control.
Use case When reflecting the changed target current of primary transfer ATVC
control
Adj/set/operate method Select the item, and then press Start key.
Display/adj/set range During operation: ACTIVE, When operation finished normally: OK!
Related service mode COPIER> ADJUST> HV-TR> 1TR-TGY/2/3, 1TR-TGM/2/3, 1TR-
TGC/2/3, 1TR-TGK1, 1TR-TK12/13, 1TR-TGK4, 1TR-TK42/43
FX-RG-H Exe of ppr side rgst displace check mode
Details To execute the mode to check side registration displacement of paper
based on the position at the Fixing Assembly.
By executing this item, a paper is picked up from the paper source
specified by FX-RGPOS and it stops at the position where a specified
length of it comes out from the Fixing Assembly.
Adjust the paper position at pickup side (inside a cassette) based on
the side registration position at that time.
Use case When feeding speed of A4 size paper is decreased
Adj/set/operate method 1) Specify a paper source by FX-RGPOS.
2) Select the item, and then press Start key.
A paper stops at the Fixing Assembly.
3) Turn OFF the main power switch.
4) Remove the Fixing Assembly, and check the side registration position
of the paper.
5) Pull out the paper, and install the Fixing Assembly.
6) Turn ON the main power switch.
7) Enter 0, and then press Start key.
8) Execute mechanical adjustment using the Adjustment Plate in a
cassette to adjust the side registration position of paper.
9) Repeat the above procedure as needed.
Caution Be sure to set A4 paper on the paper source (Cassette 2 to 4, Multi-
purpose Tray) specified by FX-RGPOS.
Related service mode COPIER> FUNCTION> MISC-P> FX-RGPOS
FX-RGPOS Spec ppr src at side reg displc ppr chck
Details To specify the paper source that is used for checking side registration
displacement of paper.
After setting A4R paper on the specified paper source, execute
COPIER> FUNCTION> MISC-P> FX-RG-H.
Use case When feeding speed of A4 size paper is decreased
Adj/set/operate method Enter the setting value, and then press Start key.
Caution Be sure to set A4 paper on the specified paper source.
Display/adj/set range 1 to 5
1: Cassette 1
2: Cassette 2
3: Cassette 3
4: Cassette 4
5: Multi-purpose Tray
Related service mode COPIER> FUNCTION> MISC-P> FX-RG-H
8
Service Mode > COPIER > FUNCTION > MISC-P
8 Service Mode > COPIER > FUNCTION > MISC-P
COPIER> FUNCTION> MISC-P
OPF-DSEQ Set of DADF pickup noise reduction
Details To set whether to control drive noise that is generated when picking up
paper (plain paper, thin paper, etc.) from DADF at 1/1 speed.
When 1 is set, noise is alleviated, but productivity is decreased (A4R,
35 ppm -> 32.2 ppm).
The setting is not applied to pickup at 1/2 speed (heavy paper).
Use case Upon user's request (to alleviate noise)
Adj/set/operate method 1) Enter the setting value, and then press Start key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: OFF, 1: ON
8-77
T-8-31
8-77