Removing The Fixing Drive Unit - Canon imageRUNNER C1335 Series Service Manual

4
Disassembly/Assembly > Fixing System > Removing the Fixing Drive Unit > Preparation
NOTE: Actions at installation
• Apply grease (MOLYKOTE HP-300 GREASE: QY9-0035) to the 2 locations [1] where the
bearings of a new Pressure Roller is installed.
[1]
• Be sure to affix felt [1] to the 2 [A] parts of the Fixing Assembly.
(If felt is already affixed, remove the old felt, clean the portion with lint-free paper
moistened with alcohol, and affix new felt.)
[1]
[A]
4 Disassembly/Assembly > Fixing System > Removing the Fixing Drive Unit > Preparation

Removing the Fixing Drive Unit

[1]
■ Preparation
1) Remove the Rear Cover 1(Refer to page 4-34).
2) Remove the Left Upper Cover (to be removed for models equipped with a fax)
(Refer to page 4-36).
3) Remove the Fax Speaker Unit (to be removed for models equipped with a fax)
F-4-359
(Refer to page 4-100).
4) Remove the Fax Unit (to be removed for models equipped with a fax)
(Refer to page 4-101).
[1]
5) Remove the Main Controller Unit(Refer to page 4-81).
6) Remove the Low-voltage Power Supply PCB Unit(Refer to page 4-93).
7) Remove the DC Controller PCB Unit(Refer to page 4-84).
8) Remove the Fixing Assembly(Refer to page 4-137).
9) Remove the Delivery/Reverse Unit (Refer to page 4-166).
[A]
F-4-360
4-141
F-4-361
4-141