Sony MVS-8000X User Manual page 162

7
Transition linked to the audio mixer
If the video signal selected in the background B row is linked to the audio mixer
in setup, then the audio mixer sound changes with the transition. That is,
pressing the [AUTO TRANS] button gives a cross fade, and pressing the
[CUT] button gives an instantaneous sound switch.
For details of setup, see "Cross-Point Settings (Xpt Assign Menu)" in Chapter
19 (Volume 3).
Notes
• The audio mixer is not linked to a snapshot or key frame transition.
• The audio mixer is not linked to a transition using the fader lever.
• If the bus-fixed mode (see page 187) is selected in the setup menu, and the
fader lever is in the lowest position, there is a cross fade from the audio
selected on the B row to the audio selected on the A row.
• The audio mixer is not linked to a key transition.
• In the following cases, the audio and video may be out of sync.
– When carrying out a cross fade in some DME wipes (for example, "picture
– When executing a preset color mix in two-stroke mode
• For details of audio mixers that can be used, contact your Sony service or
sales representative.
162
Procedure for Basic Transition Operation
For details of the settings, see the relevant section.
Super mix: "Super Mix Settings" (page 171)
Preset color mix: "Color Matte Settings" (page 172)
Wipe: "Basic Procedure for Wipe Settings" (page 293)
DME Wipe: "Basic Procedure for DME Wipe Settings" (page 349)
Clip transition: "Clip Transition Operations" (page 413)
Using the transition preview function (page 189), you can check the
transition on the preview monitor.
Carry out the transition in the transition execution section.
For a gradual transition such as a mix (dissolve) or wipe: Press the
[AUTO TRANS] button, or operate the fader lever.
To execute a transition by pressing the [AUTO TRANS] button, first
set the transition rate (specified as the duration of the transition).
(See "Setting the Transition Rate" (page 176).)
When you have selected a wipe or DME wipe as the transition type,
you can also set the transition range. (See "Pattern Limit" (page 181).)
For an instantaneous transition: Press the [CUT] button.
For details, see "Executing a Transition" (page 175).
in picture")