Sony MVS-8000X User Manual page 76

whether the [TIMELINE] button is on or
off, as follows.
When the [TIMELINE] button is on:
Displays the start and stop points of the
last set keyframe on the timeline. When
the keyframe number is changed and
the last register and keyframe change,
the display also changes. (timeline
setting mode)
When the [TIMELINE] button is off:
Displays the Cueup & Play (rewind
action) start and stop points.
b Device selection buttons
These buttons are used for selecting
assigned external devices or frame memory
clips.
Each button can only be assigned to a single
device. Carry out the assignment in the
Setup menu (see "Overall Control Panel
Settings (Config Menu)" in Chapter 19
(Volume 3)). To select an assigned device,
press the corresponding button, which
lights green. To select more than one device
simultaneously, hold down the button for
the first selection, while pressing the
buttons for the other selections in turn. The
second and subsequent selected buttons
light amber. If you press another button
without holding down the first selected
button, the second button will be the
reference device and light green.
DEV: Assign external devices DEV1 to
DEV12.
FM CLIP: Assign frame memory clips
FM1 to FM8.
Device selection buttons can be set as
SBOX buttons or DELAY button in the
Setup menu.
c SBOX (shotbox) buttons
Assign a shotbox saved in registers 1 to 99.
When you press a button, the assigned
shotbox is selected, and executed. Carry out
the assignment in the Setup menu (see
76
Names and Functions of Parts of the Control Panel
"Overall Control Panel Settings (Config
Menu)" in Chapter 19 (Volume 3)).
SBOX buttons can be set as device
selection buttons or DELAY button in the
Setup menu.
d DELAY button
When pressed, this button lights green, the
numeric keypad control block display
changes to DELAY__ : , and you can set
the start delay time for the selected device.
The setting range is from 00:00 to 59:29
(depends on the video format). This button
goes off when another timecode setting
button ([START TC], [STOP TC], [SET
START TC], [SET STOP TC], or [SET
DUR]) is pressed.
The DELAY button can be set as a device
selection button or an SBOX button in the
Setup menu. Carry out the assignment in
the Setup menu (see "Overall Control
Panel Settings (Config Menu)" in Chapter
19 (Volume 3)).
e Editing buttons
These buttons set start and stop points.
These operations are only valid while a
device is selected with the device selection
buttons.
START TC: Press this button to set the
timecode of the start point at that time.
The timecode of the start point is
updated to the current time each time
this button is pressed.
When the device the operation applies
to is a VTR/disk recorder, the start
point updated by the setting of the
[TIMELINE] button is as follows.
When the [TIMELINE] button is
On: start point of the timeline
When the [TIMELINE] button is
Off: start point of Cueup & Play
STOP TC: Press this button to set the
timecode of the stop point at that time.
The timecode of the stop point is
updated to the current time each time