Sony MVS-8000X User Manual page 109

AUX cross-point buttons
AUX CTRL (AUX control) button
6A/B bus control block
7Source/bus name displays
a AUX control block
This selects the AUX bus and the assigned
source signals.
This cross-point control block can be
switched to AUX control mode with the
[AUX CTRL] button, and the key 1 row
used as AUX delegation buttons, and the
key 2 row used as AUX bus cross-point
selection buttons, with the source name
display showing the source names or the
bus names (AUX panel-less function). To
use this function, the function for switching
to AUX control mode must first be assigned
to the [PRE MCRO] and [POST MCRO]
buttons.
For the method of making this assignment,
see Chapter 19 "Control Panel Setup
(Panel)" (Volume 3).
2AUX CTRL (AUX control) button
1 AUX control block
AUX delegation buttons: These select the
AUX bus. When you press a button,
turning it on, this selects the assigned
bus as the AUX bus. You can make the
rightmost button a [SHIFT] button, in
which case each button can be used to
select two buses.
For details of the buses that can be
selected, see "Bus Selection" (page 147).
AUX cross-point buttons: These select the
source signal to be assigned to the
AUX bus. When you press a button,
turning it on, this selects the assigned
video/key source signal and assigns it
to the bus selected with the AUX
delegation buttons. To select a key,
hold down the [KEY] button and press
the AUX cross-point button to which
the desired key signal is assigned. You
Names and Functions of Parts of the Control Panel
3DEST (destination) button
4KEY button
5AUX DSPLY (AUX
display) button
109