Sony MVS-8000X User Manual page 179

The transition control block display of the same bank (M/E or PGM/PST)
also shows the setting.
To enter a difference from the current value
After pressing the [+/–] button, enter the difference and press the [TRIM]
button.
To change the sign (+ or –), press the [+/–] button.
Setting the transition rate in the Multifunction Flexi Pad control
block
1
In the Multifunction Flexi Pad control block, press the [TRANS RATE]
button.
The button displays in the memory recall section change as shown in the
following illustration, and the Multifunction Flexi Pad control block
switches to the transition rate setting mode.
2
In the region selection buttons, select the switcher bank.
3
Press the [TRANS SEL] button in the memory recall section.
The button displays in the memory recall section change as shown in the
following illustration, and you can select the type of transition for which
to set the rate.
179
Executing a Transition