Configuration Examples; Example For Changing Static Multicast Routes To Rpf Routes - Huawei Quidway S7700 Configuration Manual - Multicast

Smart routing switch

Hide thumbs Also See for Quidway S7700:

Table of Contents

Quidway S7700 Smart Routing Switch

Configuration Guide - Multicast

9.8 Configuration Examples

Examples for configuring static multicast routes and multicast load splitting are provided.

Networking Requirements

The receiver can receive information from the multicast source. Switch A, Switch B, and Switch

C run OSPF. You need to configure a static multicast route to make the multicast path from the

source to the receiver different from the unicast path from the source to the receiver.

Figure 9-1 Networking diagram for changing static multicast routes to RPF routes

Issue 01 (2011-07-15)

Run the debugging mrm [ vpn-instance vpn-instance-name | all-instance ] { all | event |

packet [ advanced-acl-number ] | route [ advanced-acl-number ] } command in the user

view to enable the debugging of multicast routing management.

9-1, PIM-DM runs on the network and all the Switches support multicast.

Multicast static route

Physical interface

Huawei Proprietary and Confidential

VLANIF interface

9 IPv4 Multicast Routing Management