System Data Control; Pc Programming - Panasonic KX-TDA30 Features Manual

2.3

System Data Control

2.3.1

PC Programming

Description
This PBX can be programmed and administered using a personal computer (PC). There are two
programming methods:
1)
On-site Programming: System programming/diagnosis can be performed locally by connecting a
PC to the PBX directly.
2)
Remote Programming: System programming/diagnosis and data upload can be performed from
a remote location.
1.
On-site Programming:
Using the Serial Interface
(RS-232C) port
Using the USB port
Using the LAN interface (KX-
TDA100/KX-TDA200 only)
Using a modem through an
SLT port*
Using an ISDN TA interface
(64 kbps) through an ISDN
Extension Line*
*: If remote access is disabled through system programming (→ Remote Programming [810]), then
this on site programming cannot be done.
Method
The PBX has a Serial Interface (RS-232C) port which can be used
for either system administration or SMDR (→ 1.25.1 Station Message
Detail Recording (SMDR)).
The PC is connected to the USB port on the PBX, or a USB port (USB
Module) attached to a DPT.
A CTI-LINK card must be installed.
An RMT card must be installed. Assign the floating extension number
of the analogue remote maintenance (→ Modem Floating Extension
Number [811]), and dial this number from the PC to connect to the
PBX.
Assign the floating extension number of the ISDN remote
maintenance (→ ISDN Remote Floating Extension Number [812]),
and dial this number from the PC to connect to the PBX. The RMT
card is not required for this method.
This method is available only when a user-supplied ISDN TA that
supports CAPI is used.
2.3 System Data Control
Description
Feature Guide 315