Communication detail setting
■1. Communication detail setting
Key word deleting
Key word protection cancel
■2. Display operation of the communication detail setting
(1) Communication setting
Touch the target communication driver display box to set the communication parameter.
The screen switches to the detail setting screen.
Set communication parameters from this screen.
Refer to the following for the setting change operation.
1.3.3 Basic operation of settings change
Set various communication parameters of communication devices.
The settable parameters differ according to the communication device.
For the FX series PLCs, key word for protecting program in the PLC can be set.
For the FX series PLCs, key word for protecting program in the PLC can be deleted.
For the FX series PLCs, the program protection status in the PLC can be cancelled.
For the FX series PLCs, the cancelled program protection status in the PLC can be returned to the protection status
Communication using the Ethernet communication unit
If the Ethernet communication unit is assigned to an extension interface, the corresponding
communication detail setting cannot be displayed.
2 - 61