■2. Displays and key functions
The following describes the displays for the list monitor.
List display area
The status of contacts and coils is displayed as below.
16.2.18 Action for an incorrect key input
If an incorrect key is input, cancel the input contents.
(1) Before touching the
Before touching the
(2) After touching the
Write the command again.
16.2.10 Writing commands
Commands finalized by writing and inserting operations are revised (overwritten) with the program writing.
The status of contacts and coils is displayed on the left of device displays.
The same operations as in the READ mode of the FX list editor can be executed.
16.2.8 Displaying sequence programs
Ends the list monitor.
(When the list monitor is executed on the FX list editor screen, the screen is switched to the FX list
Type of instruction
LD, AND, OR (Contact instruction (Normal open))
LDI, ANI, ORI (Contact instruction (Normal close)) Contact
LDP, ANDP, ORP, LDF, ANDF, ORF
(Rise or fall contact instruction)
key (before reading/writing the input contents)
key, touch the
key (after reading/writing the input contents)
Except TC: Contact
Except TC and word
16.2 FX List Editor (GT2105-Q, GT2104-R only)
■ Not displayed
Value: Except 0
Always ■ not displayed
16 - 39