Mitsubishi Electric GOT2000 Series User Manual page 625

18.3 BOOTOS AND SYSTEM APPLICATION INSTALLATION USING DATA
STORAGE
There are the following two types for the installation of BootOS and system applications using a data storage.
■1. Installing when starting the GOT
➠
18.3.1 Installing when starting the GOT
All the system applications and project data stored in the data storage are transferred to the GOT when powering on
the GOT. This installing method is effective in the following cases.
• The GOT utility cannot be displayed.
• The system application is not installed.
■2. Installing using the data control function (Utility)
➠ 18.3.2 Installing using the data copy function (Utility)
By operating the utility, select the system application or project data stored in the data storage and transfer them to the
GOT.
18.3 BOOTOS AND SYSTEM APPLICATION INSTALLATION USING DATA STORAGE
POINT POINT POINT
Precautions on installing BootOS, system applications
(1) Installing both BootOS and system applications
After completing BootOS installation, install system applications.
When installing BootOS, the built-in flash memory in the GOT is initialized and goes to the
status at factory shipment. (All system applications and project data are erased.)
BootOS is installed in the GOT at factory shipment. It is not necessary to
install BootOS when not upgrading it.
(2) Installation cannot be interrupted.
Do not perform any of the following during a BootOS or system application installation.
Failure to do so may result in installation failure, causing the GOT malfunction.
• Powering off the GOT
• Pressing the reset button of the GOT
• Removing the data storage
If the installation failure and the GOT malfunction occur, take the following action.
• If BootOS installation failed:
Please consult your local Mitsubishi (Electric System) Service center or representative.
• If the basic system application installation failed:
➠
18.3.1 Installing when starting the GOT
18
18 - 3