I/O Check; I/O Check Function - Mitsubishi Electric GOT2000 Series User Manual

4.9

I/O Check

4.9.1

I/O check function

The I/O check is a function which checks whether GOT and PLC can communicate with each other.
If I/O check ends normally, the communication interface and the connection cable hardwares are normal.
To execute I/O check, the communication driver has to be installed in GOT in advance from GT Designer3 or GT Designer2.
Note that the GOT restarts when this function is performed.
Refer to the following for the details related to the installation of the communication driver.
➠
■1. Communication drivers inapplicable to I/O check
When the following communication drivers are used, the I/O check cannot be executed.
Connection type
MELSECNET/H connection
MELSECNET/10 connection
CC-Link IE Controller Network
connection
Connection to
MITSUBISHI
CC-Link IE Field Network
PLC
connection
CC-Link connection (Intelligent
device station)
Ethernet connection
Connection to FUJI PLC
Connection to YASKAWA PLC
Connection to YOKOGAWA PLC
Connection to ALLEN-BRADLEY PLC
Connection to SIEMENS PLC
Microcomputer connection
Inverter connection
MODBUS(R)/TCP connection
AZBIL control equipment connection
Connection to RKC temperature controller
4 - 22
4.9 I/O Check
GT Designer3 (GOT2000) Screen Design Manual
MELSECNET/H
MELSECNET/H
CC-Link IE Controller Network
CC-Link IE Field Network
CC-Link Ver.2(ID)
Ethernet (MELSEC), Q17nNC, CRnD-700, gateway
FUJI PXR/PXG/PXH
YASKAWA GL
YASKAWA CP9200(H)
YASKAWA CP9300MS (MC compatible)
YASKAWA MP2000/MP900/CP9200SH
Ethernet (YASKAWA), gateway
YOKOGAWA FA500/FA-M3/STARDOM
Ethernet (YOKOGAWA), gateway
EtherNet/IP(AB), gateway
SIEMENS S7-200
SIEMENS S7-300/400
Ethernet(SIEMENS S7), gateway
Microcomputer connection
FREQROL 500/700
MODBUS/TCP, gateway
Azbil SDC/DMC
RKC SR Mini HG (MODBUS)
Communication driver