Adjusting the clock
Synchronize the clock data of the GOT with the clock data of the controller.
The following explanation uses GT2104-R as an example.
■1. Clock adjustment setting
Reference CH No.
Time zone of target unit
Time difference from GMT
If [Adjust the clock] is deselected or [Trigger Type] is set to [Sampling] in [GOT Setup] in the project data, only [Sampling] is
selectable as the trigger type for the clock adjustment in the utility.
If [Adjust the clock] is deselected or [Trigger Type] is set to [Sampling] in [GOT Setup] in the project data, [No setting] is displayed
Switch the Use/Disuse of Adjust.
Set a reference channel of the external controller.
Set the trigger type for the clock adjustment.
• When selecting [Sampling] for [Trigger type], set the sampling interval for
the clock adjustment.
• When selecting [Rise] or [Fall] for [Trigger type], information on the device
set as a trigger is displayed.
Switch Specified/Unspecified of the time zone of target.
When selecting [Specify the time zone of target unit], set the time zone.
Time zone of target is set by specifying the time difference from GMT.
Settings of [Adjust] in the utility
Configure the settings in the utility and in [GOT Setup] on GT Designer3 by the same method.
GT Designer3 (GOT2000) Screen Design Manual
14.1 Time Setting and Display
1 to 2
Trigger type: Rise/Fall/Sampling
Sampling interval: 1 to 1440
GMT-12:00 to GMT+13:00
Hour: -12 to 13
Minute: 0, 15, 30, or 45
<Default: 0 hour 0 minute>
14 - 5