Setting Of Communication - Mitsubishi Electric F930GOT-BWD-E User Manual

Graphic Operation Terminal F930GOT
13.3.2

Setting of communication

• Setting of RS-232C (channel 0) parameters
Set the system mode driver (DF1) to "half-duplex slave (DF1)".
Set other parameters to the default values (initial values).
• Channel configuration of DF1 (half-duplex slave)
Set the parameters as shown in the table below.
Set all parameters except shaded ones to the default values.
Diagnostic File
Baud Rale
Parity
Duplicate Packet Delection
Station Address
Error Delection
Poll Timeout
RTS Off Delay
RTS Send Delay
Message Retries
Control Line
EOT Suppression
• Setting on the GOT side
When the connected PLC is set to "SLC500 Series" in the screen creation software or "SET-
UP MODE" in the GOT, the following setting is selected.
(The following setting is automatically selected when the PLC model is set to "SLC500
Series". You do not have to set them manually.)
Baud rate
Data length
Stop bit
Parity bit
Control method
Parameter
Additional Functions (in V.2.00 or later) 13
Set value

19200
Even
Disabled
0
BCC
50
0
0
3
No Handshaking
No
19200
8 bits
1 bit
even
None
13-9